1942 - 1947 CHEVROLET SHOP MANUAL

Section 0 General Information - Lubrication

	LUBRICANT KEY CL     CHASSIS LUBRICANT EO     LIGHT ENGINE OIL WB    WHEEL BEARING GREASE SG     STEERING GEAR LUBRICANT	POINTS OF LUBRICATION
		1    FRONT SPRING SHACKLES 2    GENERATOR (2 oil cups) 3    KING PIN (2 each side) 4    FRONT WHEEL BEARINGS-Clean and Repack NOTE—On C.O.E. use soft, smooth grease 5    CARBURETOR PUMP ARM SHAFT 6    TIE ROD (1 each side) 7    STEERING CONNECTING ROD (1 each end) 8    FRONT SPRING REAR EYE BOLT (1 each side) 9    IGNITION DISTRIBUTOR - Fill cup and turn down 10    STEERING GEAR 11    STARTING MOTOR (1 oil cup) 12    AIR CLEANER-Remove and clean Fil­ter Element in gasoline-Dip in engine oil and drain Fig. 6-1942 1-1/2-Ton Truck Lubrication Chart	13    UNIVERSAL JOINTS AND PROPEL­LER SHAFT SLIP JOINTS (l fitting each Joint and Slip Joint) 14    THROTTLE BELL CRANK 15    TRANSMISSION - See recommendations under "Rear Axle and Transmission Lubri­cation" 16    REAR SPRING FRONT EYE BOLT (1 each side) 17    REAR AXLE-See recommendations un­der "Rear Axle and Transmission Lubrica­tion" NOTE-2-Speed Axle Gearshift Cable (1 each end) 18    REAR SPRING SHACKLES NOTE-ENGINE-See recommendations under "En-gine Lubrication." WATER PUMP-Requires no lubrication.

<PREVIOUS PAGE    NEXT PAGE>

CONTENTS     INDEX

Old Online Chevy Manuals

WebCounter says that you are visitor number:

Please Report any Broken Links or Pages that do not load properly.  Webmaster

This Information is for Research and the Promotion of the Preservation of Older Chevys

All Names, Trademarks and Logos Belong to their Respective Owners.

Web Space Provided by